5 most common plumbing water leak repairs

5 most common plumbing water leak repairs

Here are some guidelines for the most common water leak repair cases.

Water and frost cause approximately 20 percent of property water damage claims, according to the New York Insurance Information Institute, and water affects 1.2 million homes per year. These guidelines will help you with the most common water leak repairs says plumber hamilton.

Common Plumbing Problem: Water Leakage Damage to Pipelines

Plastic supply line nuts crack and break.

Solution

Tighten plastic supply line nuts by hand only. Using a wrench will over-tighten the nuts causing internal stress that will cause them to break within days or months.

“Any wrench or pliers will overtighten the nut causing it to break,” says Rose Grant, research architect at the State Farm Building Technology Research Unit in Bloomington, Ill. “Tighten the nuts as much as you can but by hand.

Common Plumbing Problem: Roof Leaks

Water seeps around the chimney. “It’s a difficult topic and a common old-house problem,” says Patrick Huelman, associate professor of the Cold Weather Housing Program at the University of Hamilton.

Solution provided by Hamilton Plumber

This is one of the most common water leak repairs, Insert laminated wood plates behind the chimney to divert water. Remove the roof covering, place the plate and cover the grooved joints with self-adhesive membrane. Place flashing where the mat meets the chimney, intersperse tar paper with the existing tar paper, and then replace the tiles.

Common Hamilton Plumbing Problem: Foundation Leaks

The garden’s groundwater supply line has corroded and is broken. This causes water to seep through the foundation at the point where the supply line enters the house.

Solution

Inform the homeowner that the water supply line must be changed immediately. If using copper plumbing, surround it with several inches of sand before covering it with soil.

“This will allow the copper to expand and contract when the earth around the pipe cools and warms, and will insulate it from rocks that can damage the pipe,” says Grant. If the soil is corrosive or has a large amount of water, it’s not a good idea to lay copper pipe, but plastic pipe such as ABS pipe, CPVC pipe or PEX pipe. Check the code to see what materials are accepted in your area.

Common Plumbing Problem: Freezing Damage

Poorly insulated exterior wall pipes freeze and burst, causing large water leaks.

Solution

Defrost and/or replace pipe section. Find and seal cracks in joist cavities in walls (such as the outside of an electrical box). Insulate the pipe well with thick insulation, such as R15 insulation, making sure to insulate between the pipe and the outside.

“It would be best to move the pipe to a heated part of the house,” says Huelman. “But if you can’t do it, insulating it properly is also a good solution.

Common plumbing problem: water, wind and hail damage

Roof tiles are nicked, perforated or shattered after a hailstorm. “We tested more than 200 products in our lab and anything you can think of that would make the tiles resistant to hail, such as thickness, price, or warranty, has nothing to do with that. It’s all about the product’s shock resistance,” says Grant.

Solution

The installation of impact-resistant materials makes people pay less safely, especially in the central United States,” says Grant. “Among the recommendations for water damage repairs, this recommendation will make the contractor look good with the homeowner.

Old toilets used a lot of water, but did a good job cleaning the main line and removing small accumulations of sediment before it became a problem. The most efficient toilets installed today do not clean the drain lines that were designed to handle much larger volumes.

The best way to combat this problem and repair a low-flow toilet is to direct the flush from the clothes washer, which generates the largest outflow of any appliance, so it can contribute to the cleanliness of the drain lines.

For homes that are connected to the city drain, locate the clothes washer discharge as close as possible to the outlet of the house drain.

This will more efficiently clean the line from the house to the street, which often has a smaller slope than the drain line inside the house.

No Comments

Sorry, the comment form is closed at this time.